The port must be fully seated onto the housing for waterproof
»
operation. There should only be a very thin, even gap of
approximately 0.15" (4mm) between the bottom of the port and
the front of the housing.
Setting Up An External Strobe
The camera's built-in flash is not usable while the camera is installed
in the housing.
Manual Strobe Exposure
External strobes may be triggered by the camera by adding an
electrical bulkhead, hotshoe, and coordinating electrical sync cord.
Sync cords are available for Ikelite, INON, SEA&SEA, and Retra
strobes. This combination provides manual exposure only using the
strobe(s) power settings.
•
B1A Bulkhead # 46002
•
C1 Canon Manual Hotshoe # 46071
•
Compatible Sync Cord
TTL Strobe Exposure
The DS Link can be programmed to the camera's specific TTL
protocol and supports both first curtain and rear curtain sync up to the
camera's maximum flash sync speed. Exposure compensation can be
used added or subtracted in the camera. A push button and indicator
light on the side of the converter make it simple to switch back and
forth between TTL and manual exposure underwater.
•
DL5 DS Link Canon TTL Converter B1A Bulkhead and CT1 Canon
TTL Hotshoe Kit # 46076
•
Single Sync Cord # 45151 or Dual Sync Cord # 45152
15