Lubricating Control Shafts - Ikelite 6950.12 Instructions Manual

3. Press and release the push button several times to work the
lubricant into the o-ring.
4. If a push button control becomes difficult to push or if it sticks when
depressed, soak the housing in warm, soapy fresh water. After a
few minutes, operate the push button. If this does not correct the
problem, return the housing to Ikelite for maintenance.
To prevent build-up of salt, sand, or debris, the push buttons
»
should be flushed with fresh, clean water after every use.
Depress each push button while the housing is submerged in
fresh water.
If it is necessary to remove a housing push button, NEVER
»
re-use the e-clip. Push button o-ring kits include replacement
e-clips.
Push buttons look similar but vary in length. Remove and re-
»
install one push button at a time.

Lubricating Control Shafts

1. Loosen the knob set screw using a hex key.
2. Remove the control shaft from the inside of the housing.
3. Clean and lightly lubricate the shaft, including the large outer end
of the shaft.
24