Figure 19. Remove four screws and then remove the heat sink
Screw specifications
M2 x L1.8
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the fans (for Yoga Slim 7 13ACN5)
Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 36
"Remove the right-fan tape (for Yoga Slim 7 13ACN5)" on page 42
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Disconnect the fan cables from the system board and release the antenna cables from the cable
guide.
Figure 20. Disconnect the fan cables from the system board and release the antenna cables from the cable
guide
Step 3.
Remove five screws and then remove the fans.
Number of screws
4
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
43