Go to
https://support.lenovo.com/partslookup
part:
Type-C bracket
Remove the heat sink
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
Step 1.
Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2.
Loosen three screws and then remove the heat sink.
Figure 11. Remove the heat sink
Go to
https://support.lenovo.com/partslookup
part:
Heat sink
Remove the fans
Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 28
"Remove the heat sink" on page 33
Step 1.
Detach the fan cable connectors and then release the cables from the cable guide.
to look up the Lenovo part number of the following replacement
to look up the Lenovo part number of the following replacement
.
Chapter 4
Removing a FRU or CRU
33