Scotsman ND650 Service Manual page 4

ND650
FOR THE INSTALLER
Location
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
above and behind it for service. Air cooled models
require a minimum of 6 inches to the left and right
of the machine for air circulation.
Machine Stand Installation
Tip the stand on it's back and install the legs,
return the stand to the upright position. Adjust leg
levelers so that the stand does not "rock".
Counter Top or Machine Stand Installation
The base of the icemaker-dispenser must be
sealed to the object it rests upon. Food grade
silastic sealant such as Scotsman part number
19-0529-01 is recommended.
Place a bead of the sealant on the machine stand
or counter top to match the outside edge of the
cabinet base and sink.
The icemaker-dispenser is heavy: use of a
mechanical hoist is recommended to lift it to the
height required to install it.
The DMS machine stand has holes in the top that
match up with "feet" on the icemaker-dispenser.
Place the cabinet onto the machine stand, so that
the unit "snaps" into place.
In both counter top and machine stand
installations, wipe off and neatly smooth any
excess sealant. Level the machine stand and
cabinet.
Unpack and install the sink brackets. Remove the
splash panel. Fit the sink assembly onto the two
sink brackets (push the sink down over the
brackets at the back), connect the drain, and press
the sink onto the bead of sealant. Wipe off and
ATTACH SINK
DRAIN TO CABINET
DRAIN WITH
RUBBER TUBE
BRACKET
2 SCREWS PER
BRACKET
ATTACH
BRACKET
neatly smooth any excess sealant from under the
sink edge. Replace the splash panel.
March, 1989
Page 4
SEAL THE
UNIT TO
THE
COUNTER
OR STAND