Auger - Scotsman ND650 Service Manual

Scotsman nd650 ice machine: user guide
Table of Contents

Advertisement

ND650
REMOVAL AND REPLACEMENT
//////////////////////////WARNING////////////////////////////
Disconnect electrical power.
Note that the auger has very sharp edges,
handle with care.
///////////////////////////////////////////////////////////////////////
To Remove the Auger:
Turn off the water to the machine, and unclip
the evaporator drain hose, pull it down and
drain the evaporator into the bin or a container.
1. The top panel must be removed.
2. Remove ice chute cover.
3. Unscrew ice sweep.
4. Loosen band clamp and remove ice chute
body.
5. The auger and breaker/bearing may now be
removed as an assembly.
a. Unscrew 4 allen head cap screws holding
breaker to evaporator.
b. Lift up on breaker and remove auger from
evaporator.
Note: If the auger is stuck, the breaker
must be removed from the auger.
The breaker may be removed from the auger
and evaporator without disturbing the auger.
a. Use spanner wrench and unscrew
stainless breaker cover from breaker (left
hand threads)
b. Unscrew auger stud from top of auger.
c. Unscrew 4 allen head cap screws holding
breaker to evaporator.
d. Lift up & remove breaker from evaporator.
BREAKER
AND AUGER
ASSEMBLY
e. If the auger is stuck use a slide hammer
type puller to pull on the auger at the threaded
hole. The size of that hole is 5/8"-18.
Inspect the auger, the critical areas of the
auger are:
1. The auger body. It should be clean and
shining. Sometimes an auger will appear
clean when wet, but after it is dry it will be
seen to be stained. Scrub the auger with ice
machine cleaner and hot water.
///////////////////////////WARNING//////////////////////////////
Ice machine cleaner is an acid. Handle it with
extreme care, keep out of the reach of
children.
//////////////////////////////////////////////////////////////////////////
2. The water seal area. Because the auger
has been removed, the water seal will have to
be replaced. Remove the water seal top half
from the auger, and inspect the auger for
minerals clean as required.
March, 1989
Page 28
SLIDE HAMMER
PULLER

Advertisement

Table of Contents
loading

Table of Contents