Table of Contents
Advertisement
4 Shipment and on-site trans-
port
The work described in this section is only to
be performed by personnel appropriately
qualified to carry out such tasks.
4.1 Accepting the delivered
goods
After receiving the shipment, proceed as fol-
lows:
1. Compare the shipment received with the
delivery note.
2. Check the shipment for transportation
damage. Report any damage to SAM-
SON and the forwarding agent (refer to
delivery note).
4.2 Removing the packaging
from the web terminal
NOTICE
!
Risk of device damage due to foreign parti-
cles entering it.
Î Do not remove the packaging and pro-
tective films until immediately before
mounting.
1. Remove the packaging from the device.
2. Check scope of delivery (see Fig. 4-1).
3. Dispose of the packaging in accordance
with the valid regulations.
EB 6616-1/-2 EN
Shipment and on-site transport
1x TROVIS 6616-1 Web Terminal
4x Fastening screw
1x Document IP 6616-1/-2
(Important Product Information)
or
1x TROVIS 6616-2 Web Terminal
6x Mounting clips for control panel mounting
4x Fastening screw for VESA mounting
1x Document IP 6616-1/-2
(Important Product Information)
Fig. 4-1: Scope of delivery
4.3 Transporting the web
terminal
Î Protect the device against external influ-
ences (e.g. impact).
Î Protect the device against moisture and
dirt.
Î Observe the permissible transportation
temperature range of 0 to 70 °C.
4.4 Storing the web terminal
NOTICE
!
Risk of damage to the web terminal due to
incorrect storage.
Î Observe the storage instructions.
Î Avoid long storage times.
Î Contact SAMSON in case of different
storage conditions or longer storage
times.
4-1
Advertisement
Table of Contents
