Table of Contents
Advertisement
FM1202
REMOVAL AND REPLACEMENT
To Remove and Repair the Gearmotor
Assembly:
(Assuming that the procedures through removal of
the water seal have been performed.)
1. Remove the electrical wires from the gear drive
motor.
2. Unscrew the 4 cap screws holding the
gearmotor to the base of the machine.
3. Remove the gearmotor from the ice maker.
Bench test the gearmotor, check for oil leaks,
noise, and amp draw.
Electrical shock hazard.
Electrical shock can cause
personal injury.
Disconnect power before
beginning to service
components.
August 1993
To Remove the Condenser Fan Motor Assembly
1. Remove top panel.
2. Unplug the two fan motor wire leads from the fan
motors.
3. Remove the two hex head bolts from the top end
of the fan motor assembly.
4. Lift up and pull out the fan motor assembly.
5. Repair as needed.
6. To reassemble: Place the fan motor assembly
lower flange holes over the two allen head cap
screws in the base, and reinstall the hex head bolts
at the top of the assembly. Plug the fan motors
back in, and replace the top panel.
Page 28
Advertisement
Table of Contents
