How To Use; Practice First; Surface Prep - Homeright FINISH MAX C800766 Manual

PRACTICE FIRST

Practice spraying water on newspaper or cardboard. This will give you the feel of the sprayer
and familiarize you with its features. Follow the instructions for adjusting to the proper
spray pattern.
1. Make sure the spray tip is screwed on tightly. Familiarize yourself with the spray cap:
Turn its wings to adjust to a horizontal, vertical, or cone spray pattern. (See Figure A.)
2. Remove the container from the spray gun by turning it counterclockwise.
3. Firmly insert the pick-up tube. (See Figure B.) Place the pick-up tube with its angle
pointing forward if you'll be spraying mostly in the downward direction, and place it
facing backward if you'll be spraying mostly in an upward direction. This tube placement
can be adjusted/changed at any time during your project.
4. Fill the container with water and re-fasten it.
5. Plug in the sprayer.
6. Engage the trigger and wait a few seconds for the unit to start spraying the water.
7. Turn the volume control knob fully clockwise to get maximum flow. Then, turn it
counterclockwise and notice how the spray pattern changes in width and intensity.
Adjust this knob until you get a good spray pattern. (See Figure C.)
NOTE: The best distance for spraying is 4 to 10 inches (see Figure D) from the surface
you're spraying. Too far away may result in overspray (and wasted liquid), and too close
may cause liquid build-up (runs).
8. Keep a stiff wrist. Do not arch your wrist at the beginning or the end of the stroke.
(See Figure E.) Do not stop the motion of the unit while spraying. The path of the sprayer
must pass beyond the area being sprayed, and the switch must be triggered on and off
as the sprayer passes into and out of the spraying area. (See Figure F.)
NOTE: Stopping the motion of the sprayer or swinging into a new stroke pattern while
spray is being delivered will result in heavy spray build-up at the edges of the stroke.

SURFACE PREP

Thoroughly clean all objects and surfaces to be sprayed, before spraying material on them.
You may want to mask or cover areas not intended to be sprayed.
SMALL PROJECTS
This sprayer uses airflow to transfer liquid to the work piece. It is recommended that for
small projects, the user first tests the sprayer without adding liquid to the cup. The airflow
may cause small pieces to move or fall during operation. Use caution and good judgement
before spraying liquid.

HOW TO USE

FINISH MAX FINE FINISH SPRAYER
® (C800766, C900076)
5
A
B
C
D
4-10 inches
E
Correct Incorrect
F
Start Trigger Release End
ENGLISH