–
Remove cotter pin
–
6
Remove pin
–
Take off retainer spring
–
Clean the brake caliper.
–
Position new brake linings.
Info
Always change the brake linings in pairs.
E01011-10
–
Position retaining spring
–
6
Mount pin
Info
To make it easier to mount the pin, push the retainer
spring down.
Make sure the retaining spring is seated correctly.
–
Mount cotter pins
–
Position the brake caliper. Mount screws
but do not tighten yet.
–
Operate the hand brake lever repeatedly until the brake lin-
ings are in contact with the brake disc and there is a pressure
point. Fix the hand brake lever in the activated position.
The brake caliper straightens.
–
Tighten screws
Guideline
E01010-11
Screw, front
brake caliper
–
Remove the locking piece of the hand brake lever.
–
Add brake fluid to level
Guideline
A
Level
(brake fluid level
below reservoir rim)
Brake fluid DOT 4 / DOT 5.1 (
–
Position the cover with the membrane. Mount and tighten the
screws.
E01008-12
Info
Clean up overflowed or spilled brake fluid immediately
with water.
5
.
.
7
and remove the brake linings.
7
.
.
5
.
4
4
.
M8
25 Nm (18.4 lbf ft)
A
.
5 mm (0.2 in)
p. 147)
BRAKE SYSTEM 13
with the spacers
Loctite
®
243™
91