For The Plumber - Scotsman CSE60 Service Manual

CSE60

FOR THE PLUMBER

Water supply and drain connections.
1. The recommended water supply line is a 3/8"
o.d. copper tube, the water pressure must have
a minimum incoming pressure of 20 psig.
2. Connect the tubing to the 3/4"
thread water inlet fitting at the back of the ice
maker. An adapter is available, the part numbers
are: F733219-03 and F640134-00.
3. Install a shut off valve in the incoming water
line near the ice maker so that the water can be
shut off for service.
4. Connect a gravity drain line to the drain
connection at the ice maker. A minimum slope
of 1/4" fall per foot of horizontal run is
recommended. Install the drains per the local
codes.
POWER
SUPPLY
WATER
SUPPLY
SHUT
OFF
WATER FILTER
(FIELD SUPPLIED)
ELECTRICAL
1. Locate the nameplate on the lower rear panel
and check that the location source voltage and
capacity are correct for this unit. The unit is
equipped with a grounded plug connection.
Under no circumstances must the ground post
be altered or removed.
Extension cords are not permitted.
GAS / BSPP
POWER
CORD
DRAIN
December 2005
Note: Although soft, easily kinked vinyl tubing is
not recommended for a drain, a short length of
¾" ID vinyl tubing is required to connect a rigid
drain tube to the 20 mm (25/32") fitting on the
back of the machine.
A vent is recommended on the highest point of
the drain tube, and the drain tubing must be rigid
pipe. Do NOT use flexible tubing for the entire
drain system. A short section of ¾ " ID flexible
tubing and suitable hose clamps may be used to
interconnect a rigid drain system to the .78" OD
(20 mm) plastic drain fitting on the ice machine.
ADAPTER
(FIELD SUPPLIED)
Be certain that the ice maker is connected to its
own electrical circuit and is individually fused.
The maximum allowable voltage variation should
not exceed ten percent of the nameplate rating.
All external wiring should conform to the
National, State, and local electrical code
requirements. Usually an electrical permit and
the services of a licensed electrician will be
required to install the receptacle.
Page 4
LEVEL THE
UNIT