Table of Contents
Advertisement
1. Bracket
2. Bolt M5×25
3. Convex of fitting plate
4. Fitting plate
1. Blade retainer fixing slot
2. Blade retainer
1. Locking tool
1. Bracket
2. Shield (for metal blade)
5. Notch of fitting plate
6. Cut off knife
7. Screw 5×12
3. Nylon line cutting head
2. Nylon line cutting head
3. Bolt M5×18
Before you start
Installation of bracket
Fit bracket to mounting portion of angle transmission and fix the
bracket by holding fitting plate pressed from beneath and tighten
4 bolts (M5×25) lightly.
Get notches and convexes of fitting plate to face corresponding
convexes and concaves of bracket, and fix bracket tightening 4
bolts (M5×25) securely.
Fit cut off knife to the shield for nylon line cutting head using
screw (5×12).
Installing nylon line cutting head
Use only flexible, non-metallic line recommended by
YAMABIKO CORPORATION.
Fasten output shaft using locking tool securely in order
to avoid the possibility of output shaft rotating when
mounting nylon line cutting head.
Insert locking tool into a hole located on the right side of angle
transmission while forcing retainer spring to the left side. Insert
locking tool further into blade retainer fixing slot to fix output shaft.
Thread nylon line cutting head onto shaft (anticlockwise) until it is
tight.
Remove locking tool.
Method to change shield (Consult your dealer.)
There are two types of shields: namely one used exclusively for
nylon line cutting head and another one used exclusively for met-
al blade. When metal blade is used, use the shield for metal
blade.
Remove bolt (M5×18) on the right side of the shield and slide the
shield to the left and remove it. Put shield of another type into
groove and slide it to the right until it stops and be sure to fasten
with the removed bolt (M5×18).
17
CAUTION
Advertisement
Table of Contents
