Service Diagnosis - Scotsman CME1002R User Manual

CME865R & CME1002R

SERVICE DIAGNOSIS

SYMPTOM
No ice, machine does not run
No ice, compressor does not run,
rest of ice machine does.
No ice, no water over evaporators 1. Water pump does not pump
No ice, everything runs
Low ice production
POSSIBLE CAUSE
1. No electrical power
2. Circuit breaker tripped or fuse
blown
3. High pressure control open.
4. Bin level control holding
machine off
5. High temp. cut out open
6. Timer switch open
7. On/Off switch open
8. Circuit board open
1. Compressor on/off switch open 1. Check or replace switch
2. Open contactor coil
3. Liquid line valve does not open 3. Check electrical connections to
4. Pump down pressure switch
does not close
5. Thermostatic Expansion valve
clogged or does not open.
2. No water in reservoir
1. Too much heat load
2. Low on refrigerant
3. Suction pressure too high
1. Too much heat load.
2. Compressor inefficient.
3. Non condensable gasses in
refrigeration system.
September, 1994
Page 24
PROBABLE CORRECTION
1. Restore power
2. Reset breaker or replace fuse,
check for electrical fault.
3. Reset HPC, check fan motor
for proper operation, and
condenser coil for dirt.
4. Check ice level control circuit.
See page 25.
5. Hot gas valve leaks thru,
replace hot gas valve
6. Replace timer
7. Check or replace switch.
8. Replace circuit board.
2. Replace contactor
liquid line valve, check coil, check
valve operation
4. Defective switch, or liquid line
valve does not open, or low on
refrigerant; check/replace
5. Check/replace TXV.
1. Check/replace water pump
2. Check/replace water inlet valve.
1. Check for slow leak thru of
water inlet valve.
2. Check pressures, if low
find/repair leak. weigh in charge.
3. Defective compressor - replace
1. Check condenser air inlet and
water temperatures.
2. Replace compressor
3. Check head pressure, if very
high, and no other reason is
suspected, replace refrigerant
charge.