Pre-Installation Information - Scotsman CME1002R User Manual

CME865R & CME1002R

PRE-INSTALLATION INFORMATION

These two models are modular ice cube machines
that are designed to be connected to a remote
condenser.
The remote condenser coil must be of adequate
size and must NOT have been used with a
mineral oil refrigeration system. Specific Scotsman
remote condensers are recommended.
A stacking kit (KSCMS) is required for stacking
these ice machines. It interconnects the sonor bin
ice level controls. A CME865 or CME1002 may
only be stacked onto models CME865, CME1002,
MCM860, MCM1062 or CMS1002.
These models will fit any 30" wide Scotsman bin,
such as the BH550 or HTB555, without a bin top.
Other bins require a bin top.
Note: The sonar transducer, located in the base of
the machine, must NOT be covered by installation
material (such as a non-Scotsman bin top). The
transducer must have clear access to the ice to be
able to sense the ice level. See page 5 for location.
Model Number Dimensions
W" x D" x H"
CME865RE-32A 30 x 24 x 27 208-230/60/1
CME865RE-6A 30 x 24 x 27 230/50/1
CME1002RE-32A 30 x 24 x 27 208-230/60/1
CME1002RE-3A 30 x 24 x 27 208-230/60/3
CME1002RE-6A 30 x 24 x 27 230/50/1
* This number is for recharging purposes only. - Note: Beginning June 1996, 48 ounces of charge were
added to the ERC301, before that total charge was 288 oz.
Use Scotsman Remote Condenser
RCE1001 (single circuit) or ERC301 (single circuit).
Use precharged tubing kit
RTE25 (25')
RTE40 (40')
RTE75 (75')
Air Temperature
(cabinet)
0
Minimum 50 F.
0
Maximum 100 F.
Basic Electrical Min Circuit
Ampacity
16.5
-
20.5
14.3
-
Remote Condenser
Air Temperature
0
-20 F.
0
120 F.
June 1996
Page 2
Max Fuse Refrigerant Charge*
Size (R-404A)
20 336 oz.
- 336 oz.
20 336 oz.
15 336 oz.
- 336 oz.
Voltage
-5%
+10%
Water Temperature
0 .
40 F
0 .
100 F