Troubleshooting; Specifications - Panasonic MJ-CB800 Operating Instructions Manual

Before calling for service, please check through this section.
Problem
The appliance does not
turn on.
Rotation stops
abruptly.
There is abnormal
noise or vibration
increases.
The texture and
consistency of the
processed ingredients
do not turn out well.
The ingredient is
leaking.
The blade is idling.
Power Supply
Power Consumption
Operation Rating
Dimension (Approx.)
(W x D x H)
Weight (Approx.)
Capacity (approx.)

Troubleshooting

● The blender jug / mill container is not set properly.
➝ Make sure to align the marks on blender jug base / mill container base with motor
housing, then twist it firmly until you hear a "click" sound. (P. EN7)
● The container unit / blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN7)
● The protection device of overload or overheating is activated.
➝ Refer to "Overload and Overheating Protection" for inspection. (P. EN5)
● The power plug is disconnected.
➝ Insert the power plug into outlet firmly.
● The protection device of overload or overheating is activated.
➝ Refer to "Overload and Overheating Protection" for inspection. (P. EN5)
● Too much ingredients.
➝ Reduce ingredient amount.
● The container unit / blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN7)
● Some ingredients might be too difficult to process raw, e.g. pumpkin.
➝ Precook might be necessary to soften the ingredients before processing, i.e. until a fork
can easily pierce.
● Ingredient size is not according to the preparation method.
➝ Prepare accordingly to the size stated.
● The blender jug base / mill container base is not assembled tightly.
➝ Assemble it tightly. (P. EN7)
● The blender gasket / mill gasket is not attached or attached loosely.
➝ Attach it properly.
● Foreign matters are stuck around blender gasket / mill gasket.
➝ Remove them.
● The blender gasket / mill gasket is damaged.
➝ Contact Panasonic Service Centre to replace it.
● The liquid amount is not enough.
➝ Add more liquid.
● Too much ice cubes. (E.g. juice with a lot of ice)
①
Remove blender jug after rotation stops completely.
➝
②
Shake the blender jug gently.

Specifications

Juicer
Continuous (Repetition 2 min
ON, then 2 min OFF)
207 x 297 x 384 (mm)
3.6 kg
Juice Cup: 1.5 L;
Pulp Container: 2.0 L
Cause and Action
1
Blender
220 - 240 V 50 - 60 Hz
270 - 320 W
Continuous
(Repetition 3 min ON,
then 1 min OFF)
207 x 279 x 406 (mm)
3.3 kg
1.35 L
Working Capacity: 1.0 L
Wet & Dry Mill
Continuous
(Repetition 1 min ON,
then 2 min OFF)
207 x 279 x 299(mm)
2.5 kg
Working Capacity: 50 g
(coffee beans)
EN9