Leaving Program Mode; Starting And Stopping The Centrifuge; Starting The Centrifuge; The „Stop" Key - Hermle Labnet Z306 Operating Manual

OPERATION

2.5.3 Leaving program mode

To leave the program mode just press the key „prog" (11). Then inside the display „time" appears
the word „Programm".
Set the display to „programm--" (M10) with the adjusting knob (1).
All with number marked passages refer to figure 22.

2.6 Starting and stopping the centrifuge

2.6.1 Starting the centrifuge

You can start the centrifuge either with the „start" key (9) or the „quick" key (8).
By the „start" key (9) you can start stored runs or runs with manually pre-selected parameters.
When the respective pre-selected running time has ended then the centrifuge will stop automatically.
By the „quick" key (8) you can start runs, which will last just a few seconds.
By pressing the „quick" key (8) the centrifuge accelerates up to the pre-selected revolution.
In the display „time" (A-3) the passed running time is indicated from the date of pressing the „quick"
key (8).
By releasing the „quick" key (8) the centrifuge stops and the running time is indicated until the
opening of the lid.
All with number marked passages refer to figure 23
Figure 23
2.6.2 The „STOP" key
By the „stop" key (10) (see figure 24) you can interrupt the run at any time. After pressing the key the
centrifuge decelerates with the respective pre-selected intensity down to stand still.
Figure 24
20 manual.docx
Z306 Instruction
© Hermle Labortechnik GmbH