Advertisement
2. DP-scanning
Defective part
Original document
1
Contact glass assy Check the location the contact
2
FFC cable CCD
3
Home position sen-
4
sor
Scanner drive belt
5
Scanner drive gear Check that the scanner drive
6
CCD PWB
7
Control PWB
8
Y116540-5
Check description
Verify the sides of the original
document.
glass is mounted.
Check the FFC cable between
the CCD and control PWB is
properly connected. Or, verify
conduction of the wire.
Check the location the home
position sensor is mounted.
Check that the scanner drive belt
is loosely mounted.
gear is loosely mounted.
The CCD PWB is defective.
The control PWB is defective.
If the sides of the original document are
reversed, place the original document properly.
Re-mount the contact glass if it is hanged off.
Reinsert the connector if it its connection is
loose. Or, if conduction is lot, replace the wire.
Re-mount the home position sensor if it is
hanged off.
If the scanner drive belt is loosely mounted,
secure the screws.
If the scanner drive gear loosely mounted,
secure the screw.
Replace the ISU and perform U411.
(see page 1-3-54)
Replace the control PWB.(see page 2-2-12)
1-4-47
Corrective Action
Service Manual
Advertisement
