Table of Contents
Advertisement
Installation
Refrigeration Unit Installation
UNPACKING AND INSPECTING
Carefully inspect the refrigeration unit immediately upon
unpacking. Verify the equipment and parts received
against the Bill of Lading. Locate all items according to
packing list and inspect for possible damage caused by
shipping. Notify the appropriate carrier if necessary and
contact MBE immediately for replacement of parts if
discrepancies exist.
1. The Refrigeration Unit is pre-assembled in the
factory and requires a minimum installation. Locate
the following parts supplied with the unit.
2. Kit assembly includes:
-
Tab clamps for conduit, syrup and circulating and
carbonated water coils
-
Bracket for drain hose and screws for mounting
-
Four 6" legs
-
6 ft (182.9 cm) drain hose
3. Locate any of the optional Kit Assembly for
mounting to match the type of mounting required.
Install the kit as noted in the instructions supplied.
4. Record the Model Number, Serial Number and date
of installation for future reference, or to be used
when ordering parts.
2-20
UNIT INSTALLATION OVERVIEW
1. Set unit in place.
2. Connect the circuit electrically. Refer to chart.
3. Connect water supply.
4. Connect the product lines from the Bag-In-Box or
tank. See the plumbing diagrams for the tower setup
that pertains to your installation.
5. Connect the drain. Locate the drain hose, bracket,
and the two screws provided in the installation kit.
Attach the drain hose to the water bath overflow
tube located on the bottom of the refrigeration unit.
Route drain hose to a floor drain.
Screw
6. Connect the conduit lines. Two carbonated water
lines and two product output lines.
Black Water
Supply Line
Section 2
Bracket
Bottom
of Unit
Drain Hose
Braided CO
2
Gas Line
Color Coded
Syrup Lines
Part Number 000003912 6/17
Advertisement
Table of Contents
