Normal Recording - Sanyo VHR-H601 Instruction Manual

NORMAL RECORDING

POWER
1 2 3
TV/VCR
4 5 6
Ad JUMP
7 8 9
SLOW INPUT SP/SLP
0
EJECT REC
PAUSE
REW FF
PLAY
STOP
ENTER
MENU
CLK/COUNT
CH
TRACK
CLEAR
VOL VOL TV CH TV CH
TV POWER TV INPUT
Always use PAUSE for
best results when making
changes during recording.
For example: To change
channels during recording,
first press PAUSE to put
the unit in pause mode.
Then select the desired
channel on the VCR, and
press PAUSE again to
resume recording.
PREPARATION
• Turn on the power of both the VCR and TV.
• Be sure the TV is set to the VCR Output Channel (CH 3 or 4).
• If a direct VIDEO/AUDIO connection is made between the
VCR and the TV, set the TV's source selector to VIDEO.
1
Insert the video cassette that the safety tab is in place.
2
Select the desired channel by using CH/TRACK ( / ).
• If you are recording from another source via audio/video input
jacks (at the Rear), select the LINE by pressing INPUT.
3
Set the desired speed (SP or SLP) by pressing SP/SLP.
• This VCR is not designed to record in LP mode.
4
Set the MTS mode as desired (See page 16, 32).
5
Press REC once.
Recording will start. (The REC will appear)
• If a cassette with no safety tab is loaded, the cassette will be
ejected automatically.
6
Press STOP to stop recording.
• If the tape reaches the end before STOP is pressed, the VCR
will automatically stop, rewind, eject, and it will turn itself off.
To PAUSE the recording
During the RECORDING mode...
1
Press PAUSE or PAUSE/STILL on the front panel to pause
the tape.
The RECP will show on the VCR indicator panel.
2
When you want to continue recording, press PAUSE or
PAUSE/STILL on the front panel again or press REC.
• After 5 minutes in pause mode, the tape will be stopped
automatically to protect the tape and the video heads.
To record one TV program while watching another
1
Press TV/VCR to select the TV mode during recording.
The VCR indicator disappears.
2
Using the TV, select the channel to be viewed.
25