Setting The Setup Menu - Sanyo VHR-H601 Instruction Manual

SETTING THE SETUP MENU

MAIN MENU
CLOCK
PROGRAM
TUNING
SETUP
SELECT ENTER
TO EXIT PRESS
SETUP MENU
FUNCTION OSD : ON
LANGUAGE SELECT:ENGLISH
AUDIO MODE: HI-FI
BROADCAST TYPE: STEREO
AUDIO OUTPUT: STEREO
SELECT ADJUST
TO EXIT PRESS
D D E E
Press or to choose a
desired item on the
SETUP menu. Then press
F F or G G to choose a
desired setting.
16
FUNCTION OSD
The onscreen display of this VCR can be turned on or off.
The FUNCTION OSD is switched between ON and OFF by
pressing F F or G G .
LANGUAGE SELECT
The onscreen programming of this VCR can display in either
English, Spanish, or French.
The LANGUAGE SELECT is switched among ENGLISH,
SPANISH and FRENCH by pressing
AUDIO MODE DISPLAY
The VCR has two separate audio playback systems, the high qual-
ity VHS Hi-Fi system and standard NORMAL mono system. The
same audio is generally recorded on both systems. The VHS Hi-Fi
system plays on separate (left and right) channels, and the NOR-
MAL system plays monaural sound. The normal track is always
played so the cassette can be played on a VCR that does not have
VHS Hi-Fi.
The AUDIO MODE is switched between HI-FI and NORMAL
by pressing F F or G G .
BROADCAST TYPE DISPLAY (STEREO/SAP/MONO)
Multichannel Television Sound (MTS) carries stereo and/or
Second Audio Program (SAP) bilingual signals. Set this display
to the desired position when both MTS stereo and SAP signals
are received. When only one of the MTS signal is received, the
VCR automatically selects the corresponding receiving mode
(Stereo or SAP) regardless of the selected position.
For normal operation, the display should be in the STEREO posi-
tion. The VCR will then record a STEREO program when available,
and record a mono program IF the program NOT IN STEREO.
The BROADCAST TYPE is switched among STEREO, SAP,
and MONO by pressing
• For weak STEREO and/or SAP broadcasting, changing the
display to mono may give clearer sound.
AUDIO OUTPUT DISPLAY (STEREO/LEFT/RIGHT)
Used during playback [when AUDIO MODE display (HI-FI/NOR-
MAL) is in HI-FI position] for selecting the audio output signals from
the AUDIO OUT terminals (L ch and R ch), and VHF/UHF/CATV.
This display setting should normally be left in the stereo position,
so that when a stereo tape is played, the stereo sound will be
heard through the left and right channels. If a mono tape is
played and the audio output is set to stereo, the same mono
sound will be heard from both left and right channels.
The AUDIO OUTPUT is switched among STEREO, LEFT, and
RIGHT by pressing F F or
F F or G G .
F F or G G .
G G .