Normal Recording - Sanyo TSL-4024P Instruction Manual

NK4QG/EX (TLS-4024P GB) Tue. Sept., 10/2002

NORMAL RECORDING

Normal Recording
Before starting
œ Turn the power on to all devices used.
œ Load a cassette tape with its erasure-prevention tab
intact.
œ Set the ON SCREEN switch to the "ON" position.
NOTE:
œ If "TAPE IN MODE" is set to "REC" in the
(GENERAL SET) menu, recording will start.
1 Press the REC/PLAY SPEED l button to set the
recording speed mode.
ø The recording speed mode appears on-screen
and on the digital display.
2
Press the REC button.
ø The record indicator "a" lights.
ø Recording starts.
ø If the tape end is reached while recording,
"OFF" is displayed on the digital display and the
unit goes into the mode set at the "TAPE END
MODE" setting in the (GENERAL SET) menu.
To cancel the "OFF" display, press the STOP,
EJECT, FF, REW or PLAY button.
ø When the end of the tape is reached, the TAPE
END OUT terminal output will be 0V. To cancel
the output, press the STOP button.
3
To stop recording, press the STOP button.
NOTES:
œ A tape recording made on this VCR may not play
back with the same degree of clarity on a time lapse
video cassette recorder from another manufacturer.
œ If you press the REC button and the loaded cassette
has no erasure-prevention tab, the VCR will eject the
cassette.
English
[Recording Speed Mode]
Maximum
Recording Recording
recording
speed mode interval
duration
(hour mode) (second)
(hours)
3 3
12 15
24 27
000 Single image recording
19
Audio
Tape motion
recording
1/50
5/50 Possible Continuous
9/50
Not possible Intermittent