Sony CDP-CX355 Operating Instructions Manual page 5

Hookups
When connecting the audio cord, be sure to match the
color-coded cord to the appropriate jacks on the
components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
CD player
2ND CD ANALOG
IN OUT
L
R
• If you have a digital component such as a digital
amplifier, D/A converter, DAT or M D
Connect the component via the DIGITAL OUT (OPTICAL)
connector using an optical cable (not supplied). Take off the
cap and plug in the optical cable.
Optical cable (not supplied)
CD player
DIGITAL
OUT
OPTICAL
Note
When you connect via the DIGITAL OUT (OPTICAL)
connector, noise may occur when you play CD software
other than music, such as a CD-ROM.
If you have a Sony component w ith the CONTROL
A1 jack
Connect the component via the CONTROL A1
You can simplify the operation of audio systems
composed of separate Sony components. For details, refer
to the supplementary "CONTROL A1
instructions.
Downloaded from: https://www.usersmanualguide.com/
Amplifier
INPUT
CD
L L
R R
POC-15
Digital component
DIGITAL INPUT
OPTICAL
Control System"
When using another Sony CD player together w ith
this player
You can make the supplied remote effective only for this
player.
• When using the player equipped with the
COMMAND MODE selector:
Set the COMMAND MODE selector of this player to
CD 1 and that of another player to CD 2 or CD 3. Then
set the CD 1/2/3 switch on the remote supplied for
each player accordingly.
• When using the player not equipped with the
COMMAND MODE selector:
The command mode of the player without the
COMMAND MODE selector is set to CD 1. Set the
COMMAND MODE selector of this player to CD 2,
and set the CD 1/2/3 switch on the remote to CD 2.
Connecting the AC pow er cord
Connect the AC power cord to a wall outlet.
Note on placement
Be sure to place the player on a horizontal place.
If the player is slanted, it may cause malfunction or
damage the player.
jack.
Get t ing St art ed
Get t ing St art ed Playing CDs
5 US