Service And Repair; Doors; Removing And Reinstalling The Door - Bosch 500 Series Service Manual

58300000202181 ARA EN B
6

SERVICE AND REPAIR

CAUTION


Sheet metal parts often have sharp edges. Avoid injury by
handling these parts with care.

Turn off the electrical power circuit to the oven at the main junction
box before servicing this unit.

For those checks requiring the use of electrical power, exercise
extreme care.

6.1 Doors

The serviceable parts of the door assembly include the handle,
endcaps, outer door glass/skin (service assembly), two spring hinges,
2-pane glass pack, porcelain-coated door liner, and the various
fasteners.
On double ovens, the Bosch logo is located on the upper oven door
skin.
6.1.1

Removing and Reinstalling the Door

 CAUTION
Avoid injury when removing and replacing oven doors.

Be sure oven is cool enough for handling.

Position hinges properly (see Figure 6).

Grasp only by sides, not by the handle.

Do not force door open or closed.

Handle with care–the door weighs approximately 40 lb.
Copyright by BSH Home Appliances Corporation
This material is intended f or the sole use of BSH authorized persons and may contain conf idential and proprietary inf ormation. Any unauthorized rev iew, use, copy ing, disclosure, or distribution in any f ormat is prohibited.
Novemb er 2018
To remove the door...
Figure 6 Opening the hinge lever

It may be necessary to use a tool, such as a screwdriver, to gently
pry the upper part of the lever away from the housing. Take care to
avoid scratching the porcelain.
To reinstall the door...
1901 Main St ▪ Suite 600 ▪ Irvine, CA 92614
Service Manual for Bosch 500 Series Built-in Wall Ovens
1. Open door completely.
2. Flip right and left hinge levers back to open, as shown below;
be sure the levers are in the fully open position.
NOTICE
3. Partially close the oven door until it is open about 7"; you will
feel the door catch on the hinge-stop levers.
4. Using both hands, lift door upward and outward to disengage
the hinges from the hinge receiver slots.
5. Set the door aside on a protected flat surface.
1. Hold the door firmly in both hands and position the hinges in
the hinge receivers, so that the slot in the base of the hinge (A)
engages with the hinge receiver (B).
Page 13 of 41
800 944-2904