Remove The Touchpad Assembly - Lenovo IdeaPad S540-15 Hardware Maintenance Manual

Remove the touchpad assembly

Make sure the following FRUs (or CRUs) have been removed.
"Remove the lower case" on page 33
"Remove the battery pack" on page 34
"Remove the speakers" on page 36
"Remove the coin-cell battery" on page 37
"Remove the memory module" on page 38
"Remove the M.2 solid-state drive" on page 39
"Remove the storage drive" on page 40
"Remove the Wi-Fi card" on page 42
"Remove the I/O board" on page 44
"Remove the fan" on page 45
"Remove the heat sink" on page 47
"Remove the LCD module" on page 48
"Remove the fingerprint board" on page 50
"Remove the system board" on page 52
Step 1. Peel off the conductive tape from the touchpad.
Figure 46. Peel off the conductive tape
Step 2. Remove the 6 screws.
54
Hardware Maintenance Manual