Installing The Appliance - SonicWALL 1RK52-110 Safety And Regulatory Information Manual

Safety and Regulatory Guidelines

Installing the appliance

•
• Lithium battery warning
• Cable connections
Installing the appliance
WARNING: The following conditions are required for proper installation:
The SonicWall appliance is designed to be mounted in a standard 19-inch rack mount cabinet.
1
Use the mounting hardware recommended by the rack manufacturer and ensure that the rack is
2
adequate for the application.
Ensure that no water or excessive moisture can enter the unit.
3
Allow unrestricted airflow around the unit and through the vents on the side of the unit. A minimum of
4
1inch (25.44mm) clearance is recommended.
Route cables away from power lines, fluorescent lighting fixtures, and sources of noise such as radios,
5
transmitters, and broadband amplifiers.
Install in a location away from direct sunlight and sources of heat. A maximum ambient temperature of
6
104º F (40º C) is recommended.
If installed in a closed or multi-rack assembly, the operating ambient temperature of the rack
7
environment may be greater than the room ambient. Therefore, consideration should be given to
installing the equipment in an environment compatible with the maximum recommended ambient
temperature.
Mount the SonicWall appliances evenly in the rack in order to prevent a hazardous condition caused by
8
uneven mechanical loading.
Four mounting screws, compatible with the rack design, must be used and hand-tightened to ensure
9
secure installation. Choose a mounting location where all four mounting holes line up with those of the
mounting bars of the 19-inch rack mount cabinet.
A suitably rated and approved branch circuit breaker shall be provided as part of the building
10
installation. Follow local code when purchasing materials or components.
Consideration must be given to the connection of the equipment to the supply circuit. Appropriate
11
consideration of equipment nameplate ratings must be used when addressing this concern. Do not
overload the circuit.
This equipment must be grounded. The power cord for the product should be connected to a socket or
12
outlet with earthing connection. Reliable grounding of rack-mounted equipment must be maintained.
Particular attention must be given to power supply connections other than direct connections to the
branch circuits, such as power strips.
The included power cord(s) are approved for use only in specific countries or regions. Before using a
13
power cord, verify that it is rated and approved for use in your location.
SonicWall NSa 2700-3700
Safety and Regulatory Reference Guide
2