Listening To The Radio - HoMedics iSoundSpa SS-7000A-RT Instruction Manual And Warranty Information

Connection
iPod ® Shuffle
Cable
Listening to a non-docking iPod
portable audio devices
If you are using an iPod without a docking port, other MP3 player, or other
portable audio device, you can play it through the iSoundSpa via
the Aux Jack located on the back of the unit.
1. Plug one end of the Connection Cable (included) into the headphone or
line-out jack on your MP3 device and the other end of the Connection
Cable into the iSoundSpa Aux jack, located on the back of the unit (Fig. 5).
2. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
3. Toggle through the AUDIO BUTTON on the unit until you reach the
auxiliary mode (Fig. 1). The AUX ICON will appear in the lower right
hand corner on the LCD display to indicate that the auxiliary mode
has been selected (Fig. 2).
4. Turn on and play your MP3 device.
5. Use the VOLUME KNOB on the unit to adjust the system volume (Fig. 1).
Note: You may need to adjust the volume on your MP3 device too.
6. To turn off the unit, press the POWER BUTTON.
Note: You also need to turn off your MP3 device too.
Aux
Figure 5 Figure 5a
® or other
1 0
Listening to Nature Sounds
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Select the nature sound you wish to listen to and press the
corresponding button (Fig. 1).
3. Turn the VOLUME KNOB on the unit to adjust the system volume (Fig. 1).
4. To turn off the nature sounds, press the POWER BUTTON to turn it off, or
switch the audio mode by pressing the AUDIO BUTTON (Fig. 1).
Note: When the unit is turned on, it will always default to the
last mode used.

Listening to the Radio

Extend FM wire antenna fully for best FM reception (do not strip, alter or
attach to other antennas).
Snap the AM loop antenna into the base provided. Next, plug the AM loop
antenna into the connecter located on the back of the unit for best AM
reception (Fig 5a).
1. Press the POWER BUTTON on the unit to turn it on (Fig. 1).
2. Toggle through the AUDIO BUTTON to play the radio (Fig. 1). The
RADIO ICON will appear in the lower right hand corner on the LCD
display to indicate that the radio is on (Fig. 2).
3. Slide the AM/FM SWITCH located on the back of the unit to select
AM or FM band (Fig. 4).
4. Turn the SET +/- KNOB on the unit to tune in the desired station (Fig. 1).
5. Turn the VOLUME KNOB on the unit to adjust the system volume (Fig. 1).
6. To turn off the unit, press the POWER BUTTON.
1 1