Maintenance; Specifications - Sanyo DWM-450 Instruction Manual

SYMPTOM
The operation or display is not normal.
The remote control does not work properly.
SERVICING:
Should this product require service, refer to the SANYO DVD limited warranty.
If you do not have a convenient SANYO service station nearby, contact the SANYO dealer where you purchased the unit. Be
sure to give the model number and explain the problem. The dealer will advise you how to obtain service.
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO DIS-
CONNECT THE AC POWER CORD BEFORE PRO-
CEEDING WITH ANY MAINTENANCE OR CLEANING.
Type:
DVD Video player
Signal format:
NTSC color
Laser:
Semiconductor laser, wavelength 650 nm/790 nm
Frequency range (digital audio):
4 Hz to 44 kHz (DVD fs: 96 kHz)
Signal to noise ratio:
More than 96 dB
Harmonic distortion (digital audio):
0.01 %
Wow and flutter:
Below measurable level
IMPORTANT INFORMATION
Because its products are subject to continuous improvement, SANYO reserves the right to modify product designs and specifications
without notice and without incurring any obligation.
POSSIBLE CAUSE
The unit must be reset.
The batteries in the remote control are weak,
or installed incorrectly.
The remote control is not aimed at the re-
mote sensor window.

MAINTENANCE

Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water
and wrung dry. Never use benzol, benzene or other strong
chemical cleaners since these could damage the finish of your
unit. It is important that no liquid reaches the inside of the
unit.

SPECIFICATIONS

Outputs:
S-VIDEO OUT:
COMPONENT VIDEO OUT:
AUDIO OUT:
VIDEO OUT:
COAXIAL:
Power requirements:
AC 120 V, 60 Hz
Power consumption:
11 Watts
Dimensions (W x H x D):
Approx. 14.2" x 2" x 9.5" (360 x 50.5 x 237 mm)
Weight:
Approx. 3.5 lbs (1.6 kg)
-E36-
CORRECTIVE ACTION
1. Disconnect the power cord.
2. Reconnect the power cord.
3. Resume operation.
Check the battery polarity (+ or –).
Replace the batteries. (See page E6.)
Aim the remote control at the remote sensor
window. (See page E6.)
Y: 1.0 V (75 Ω)
p-p
C: 0.286 V (75 Ω)
p-p
Y: 1.0 V (75 Ω)
p-p
P : 0.7 V (75 Ω)
b p-p
P : 0.7 V (75 Ω)
r p-p
2 V rms
1.0 V (75 Ω)
p-p
Coaxial digital output