Table of Contents
Advertisement
• IP
The IP is set Dynamic by default. Select to change Fixed IP according to your
network condition.
• DNS
The DNS is set Dynamic by default. Select to change <Fixed> DNS according to your
network condition.
• LAN Network
Connect the Tuner's Ethernet port to one of the LAN ports in a router or Wi-Fi router using
CAT 5 or CAT 6 cable. If your Router or Wi-Fi router is DHCP-enabled (recommended),
you don't have anything to setup and the Tuner will connect to Internet with the
parameters automatically assigned by the Router/Wi-Fi router.
Use the remote control for configuration if you want to use a fixed IP, scroll to
IP:[Dynamic] and press OK. Choose Fixed. Press the ▲ button, you can then enter the
IP, press ▲, ▼ to tune to the required numbers: xxx.xxx.xxx.xxx. Switch among the 4
groups by pressing ◄► . When done, press OK. Scroll to GW and NM to do the same.
You can also choose to use a DNS server other than the one from the DHCP server.
Scroll to DNS and do the same.
Note - Use DHCP to get the network parameters unless you are familiar with
network setup.
Date and Time
The radio will set your local time automatically after the internet connection is
completed. If you want to do manual setting, change it by the following options:
• Time zone
Auto-set Time Zone: This option is set by default.
Manual-set Time Zone: Choose this option if you want to set the time in another
• Set Time Format
Choose either 12-hour or 24-hour notation you prefer.
• Set Date Format
region.
Choose and highlight the region/city you prefer and press OK
to confirm.
Coupled with NTP (use network time) and DST (Daylight time
saving) will be adjusted automatically if you choose to use
network time (NTP).
-18-
11. Configuration
Advertisement
Table of Contents
