Easy Assembly, How To Install Wall Mount, How To Charge Battery And Battery Indicator Lights - Eureka NEC 380 Series Owner's Manual

Easy assembly
1
. Slide wand onto hand vacuum
until it clicks (Fig. 1).
. Push wand into motorized floor
2
nozzle until it clicks (Fig. 2).
How to install wall mount
• Choose location near power outlet.
Locate point high enough on wall
to allow wand and motorized floor
nozzle to hang freely.
• Place mount against wall and use
pencil to mark drill holes.
• Drill holes (with 1/4" bit) and insert
drywall anchors. Insert screws
through holes on mount and tighten
until firmly attached (Fig. 3).
How to charge battery and
store accessories
• Place assembled vacuum cleaner
on wall mount.
• Plug charger into power outlet and
then into charger port on handle
(Fig. 4).
• Loop charger cord into clips on
sides of wall mount.
Battery indicator lights show
level of charge (Fig. 4):
A. Fully charged
B. Half charged
• Indicator lights stop blinking when
fully charged.
• Charge battery fully before using for
the first time. This may take up to
six hours.
6
Eureka Customer Service HELPLINE 1-800-282-2886
NEC380IMv4.indd 6 NEC380IMv4.indd 6
1
Click!
2
Click!
3
Drywall anchors
Cord
4
B
1/16/20 1:15 PM 1/16/20 1:15 PM
clip
A