JVC EverioR GZ-RY980 Detailed User Manual page 82

Using Wi-Fi
Connection Adapter Settings and Camera Connection
o
1
Launch the wizard screen and tap 1.
"Preparation on the Camera" (A p. 79)
Available Adapter
.
2
Select "Connect with Access Point", followed by tapping 1.
Connect with Access Point
.
3
Select "Internet connection", followed by tapping 1.
Internet connection
.
4
Select the method of configuration and tap 1.
Configure WPS here.
WPS
.
5
Press the WPS button on the access point.
For more information, please refer to the instruction manual of the
access point.
6
Tap "WPS".
WPS Setup
Press the WPS Button
on the Access Point
then Touch the WPS Button
.
82
Wireless LAN
WPS
7
A connection successful screen appears.
Connected
Successfully Connected.
Please Continue Settings.
.
Follow the instructions on the screen to configure "HTTP Port"/"UPnP"/
"DDNS"/"Username"/"Password".
HTTP Port:
0
Configure the port number for connecting to the Internet. This is
usually set to "80".
UPnP:
0
Set to "On" if the UPnP protocol can be used to connect the device
to the network.
DDNS:
0
Configure the environment for connecting to the Internet. This is
usually set to "On".
Username:
0
Configure a user name for the acquired DDNS account.
Password:
0
Configure a password for the acquired DDNS account.
For non-WPS, information such as SSID, type of encryption,
0
passphrase and IP address ("DHCP" or "Manual") also need to be
configured.
Memo :
It is also possible to configure the connection settings in the "Settings" tab
0
after direct connection is established and upon access to the main page
of the camera via the web browser. "Changing Connection Settings"
(A p. 94)