Use; Change Direction Of Rotation/Unlock Appliance; Switching On And Off; Adjusting The Rotational Speed - Parkside PBSA 12 F5 Translation Of The Original Instructions

Use

Change direction of rotation/
unlock appliance
♦ Unlock the appliance and change the direction
of rotation by pressing the rotation direction
switch towards the left or right.
Switching on and off
Switching on
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in. The LED
working light lights up when the ON/OFF
switch is depressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off
♦ Release the ON/OFF switch
the appliance.

Adjusting the rotational speed

The ON/OFF switch
control. Press the ON/OFF switch
low speed. Increasing the pressure increases the
speed.
NOTE
► The integrated motor brake ensures rapid
stoppage.

Activate lock

♦ Push the rotation direction switch
middle position. The ON/OFF switch
blocked.
■ 8 │ GB │ IE
to switch off
has a variable speed
lightly for a
into the
is

Tips and tricks

Tip! This symbol indicates proper
behaviour.
♦ Before operating the appliance, check whether
the screw or drill bit is correctly positioned, i.e.
centred in the drill chuck.
♦ Screw bits are labelled according to their
dimensions and their shape. If you are uncer-
tain, always check whether the bit fits tightly in
the screw head without any free play.
Torque
♦ Smaller screws/bits can be damaged if you set
the torque or rotational speed too high.
Hard screw joints (in metal)
♦ Particularly high torques occur, for example, in
metal screw joints made using drive sockets.
Select a low rotational speed.
Soft screw joints (e.g. in soft wood)
♦ Again, use a low rotational speed, for example
to avoid damaging the surface of the wood on
contact with the screw head. Use a countersink.
When drilling in wood, metal and
other materials, observe the following
♦ Use a high speed for drill bits with a small
diameter and a low speed for drill bits with a
large diameter.
♦ Select a low speed for hard materials and a
high speed for soft materials.
♦ Secure or fasten the workpiece in a clamp or
vice (if possible).
♦ Mark the spot where you want to drill using a
centre punch or nail. Select a low rotational
speed when starting.
♦ Pull the rotating drill bit from the hole repeatedly
to remove dust and chips and clear the hole.
PBSA 12 F5