Changing Tools; 2-Speed Gearbox; Removing The Chuck; Using The Bit Adapter - Parkside PBSA 12 D3 Translation Of The Original Instructions

Changing tools

Your cordless screwdriver has a fully automatic
spindle lock .
When the motor is stopped, the power train locks
so that the quick-release chuck
by turning it . After you have attached the
desired tool and tightened it by turning the chuck
, you can continue working. The spindle lock is
automatically released when the motor starts
(ON/OFF switch pressed).

2-speed gearbox

CAUTION!
► Operate the speed selector
the appliance is at a standstill. Otherwise the
appliance can be damaged.
In first gear (speed selector
you can reach a speed of approx. 350 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (speed selector
you can reach a speed of approx. 1300 rpm for
carrying out drilling work.

Removing the chuck

If you want to use the bit adapter
remove the quick-release chuck
Removing the chuck:
♦ Hold the quick-release chuck
front.
♦ Pull/push the chuck ring
the quick-release chuck
The quick-release chuck
can be removed towards the front.
Attaching the quick-release chuck:
♦ To replace the quick-release chuck
chuck ring towards the quick-release chuck
10a
. Push the quick-release chuck
adapter . Let go of the chuck ring
the quick-release chuck
PBSA 12 D3
can be opened
only when
in position: 1)
in position: 2)
, you must
.
firmly from the
in the direction of
10a
.
is now unlocked and
, pull the
over the bit
to click
10a
into place.
NOTE
► If the quick-release chuck
automatically click into place, turn the chuck
ring .
10a

Using the bit adapter

After removing the quick release chuck
use the bit adapter .
♦ Insert a suitable bit into the bit adapter
♦ Push the bit into the bit adapter
stop.
The guidance and the magnetic holder keep the
bit firmly in place.
♦ Pull the bit out of the bit adapter

Torque selection ring/drill setting

You can set the torque using the torque selection
ring .
♦ Select a low level for small screws or soft
materials.
♦ Select a high level for large screws, hard materi-
als or removing screws.
♦ Select the drill setting for drilling work by
adjusting the torque selection ring
position .
♦ Push the speed selector
work (position: 2).

Use

Change direction of rotation/unlock
appliance
♦ Unlock the appliance and change the direction
of rotation by pressing the rotation direction
switch towards the left or right.
Switching on and off
Switching on:
♦ To start the appliance, press the ON/OFF
switch and keep it pressed in. The LED work-
ing light lights up when the ON/OFF switch
is depressed lightly or fully. This provides
illumination of the work area in poor lighting
conditions.
does not
, you can
.
as far as the
.
to the
forward for drilling
GB │ IE │
21