Table of Contents
Advertisement
Available languages
Available languages
▶ Before using the crimping tool, make sure there are no concealed electric cables or gas or water pipes
in the working area. External metallic or live parts can give you an electric shock if you inadvertently
damage electric cables or gas or water pipes.
▶ Do not crimp live parts, i.e. parts carrying electric voltage. The crimping tool must be considered as being
uninsulated and must therefore be used in combination with personal protective equipment (protective
gloves, protective footwear, protective clothing, etc.) of a type suitable to provide protection for yourself
and other persons in the vicinity. It is essential to ensure adequate insulation for working in the vicinity of
electrically live lines, for example by the use of solid insulating material or maintenance of an adequate
air gap. The crimping tool is, amongst others, suitable for use on electrically insulating aerial lifts or
platforms.
▶ In order to use the crimping tool in the vicinity of electrically live lines, the user must:
▶ take all different potentials (voltages) into account.
▶ make sure that all chosen measures and tools are appropriate for the application.
▶ be trained for working on electrically live lines.
▶ wear suitable personal protective equipment.
▶ wear appropriate, close-fitting clothing.
▶ remove metallic lifestyle accessories such as jewelry.
Power tool use and care
▶ After approx. 50 consecutive crimping operations, switch the power tool off and allow it to cool down for
about 15 minutes. Overheating can lead to damage to the crimping tool.
▶ Store the crimping tool in a dry place inaccessible to children and unauthorized persons.
2.3
Careful handling and use of batteries
▶ Observe the special guidelines applicable to the transport, storage and use of lithium-ion batteries.
▶ Do not expose batteries to high temperatures, direct sunlight or fire.
▶ Do not disassemble, crush or incinerate batteries and do not subject them to temperatures over 80 °C
(176 °F).
▶ Do not use or charge batteries that have suffered mechanical impact, have been dropped from a height
or show signs of damage. In this case, always contact your Hilti Service.
▶ If the battery is too hot to touch it may be defective. Put the battery in a place where it is clearly visible
and where there is no risk of fire, at an adequate distance from flammable materials. Allow the battery to
cool down. If it is still too hot to touch after an hour, the battery is faulty. Contact Hilti Service.
3
Description
3.1
Product overview
3.2
Intended use
The product described is an uninsulated, cordless, electro-hydraulic crimping tool.
It is designed for crimping connectors made of copper (Cu) or aluminum (Al).
Before use of the power tool, all live cables or other items carrying electric voltage within the area in which
the user is working must be switched off. If this is not possible, the corresponding safety precautions for
working in the proximity of live cables or equipment must be implemented and observed.
*2188462*
1
2188462
Crimping / pressing head
@
Piston reset slider for use in case of fault or
;
emergency
Servicing and fault indicator (red LED)
=
Battery release button
%
Battery
&
Slot on both sides to fasten the Hilti retaining
(
leash
White LED to illuminate the working area
)
Control switch
+
Crimping / pressing ram (stepped)
§
Pivoting bar to open the tool head
/
Lever to lock/unlock the tool head
:
English
5
Advertisement
Table of Contents
