Tilt Support Lever For Power Trim And Tilt Model; Top Cowling Lock Lever (Pull Up Type); Flushing Device - Yamaha LF115 Owner's Manual

Components
2. Bolt
3. Cap
Bolt tightening torque:
42.0 Nm (4.2 kgf-m, 31 ft-lb)
EMU26341
Tilt support lever for power trim and
tilt model
To keep the outboard motor in the tilted up
position, lock the tilt support lever to the
clamp bracket.
1. Tilt support lever
ECM00660
NOTICE
Do not use the tilt support lever or knob
when trailering the boat. The outboard
motor could shake loose from the tilt sup-
port and fall. If the motor cannot be trail-
ered in the normal running position, use
30
A
B
ZMU01863
1
ZMU03979
an additional support device to secure it
in the tilt position.
EMU26382

Top cowling lock lever (pull up type)

To remove the engine top cowling, pull up
the lock lever(s) and lift off the cowling.
When installing the cowling, check to be sure
it fits properly in the rubber seal. Then lock
the cowling by moving the lever(s) down-
ward.
1. Top cowling lock lever(s)
1. Top cowling lock lever(s)
EMU26460

Flushing device

This device is used to clean the cooling wa-
ter passages of the motor using a garden
hose and tap water.
TIP:
For details on usage, see page 71.
1
ZMU04225
1
ZMU04226