Connecting Projector; Terminals Of Projector - Sanyo PLV-70 Owner's Manual

CONNECTING PROJECTOR

This projector has input and output terminals on its back for connecting computers and video equipment. Refer to figures on
pages 11 to 13 and connect properly.
COMPUTER AUDIO
INPUT (1 and 2) JACKS
Connect an audio output
(stereo) from computer to
these jacks.
(Refer to P12.)
RESET BUTTON
This projector uses a micro processor
to control this unit, and occasionally,
this micro processor may malfunction
and need to be reset. This can be
done by pressing RESET button with a
pen, which will shut down and restart
unit. Do not use RESET function
excessively.
Do not press this button. This button
is used for our optional accessories.
5 BNC INPUT JACKS
Connect component video
output (Y, Cb, Cr or Y, Pb, Pr)
from video equipment to
VIDEO/Y, Cb/Pb and Cr/Pr
jacks or connect computer
output {5 BNC Type (Green,
Blue, Red, Horiz. Sync and
Vert. Sync.)} from computer
to G, B, R, H/V and V jacks.
(Refer to P12 and 13.)

TERMINALS OF PROJECTOR

COMPUTER INPUT
TERMINALS (DIGITAL/ANALOG)
Connect computer (digital/analog)
output to one of these terminals.
(Refer to P12.)
ANALOG
AUDIO 1
G
VIDEO/Y
VIDEO/Y Cb/Pb
VIDEO INPUT JACKS
Connect composite video
output from video equipment
to VIDEO/Y jack or connect
component video outputs to
VIDEO/Y, Cb/Pb and Cr/Pr
jacks. (Refer to P13.)
INPUT 1
DIGITAL(DVI-D)
R/C JACK
CONTROL PORT
RESET
AUDIO 2
B R H/V V
Cb/Pb Cr/Pr
INPUT 2
S–VIDEO
Cr/Pr R–AUDIO–L
( MONO )
INPUT 3
AUDIO INPUT JACKS
Connect an audio output
from video equipment to
these jacks.
(Refer to P13.)
R/C JACK
When using Wired/Wireless
Remote Control Unit as Wired
Remote Control, Connect
Wired Remote Control Unit to
this jack with Remote Control
Cable (supplied).
CONTROL PORT CONNECTOR
When controlling this projector
by computer, connect your
computer to this terminal.
(Refer to P12.)
S-VIDEO INPUT JACK
Connect S-VIDEO
output from video
equipment to this
jack. (Refer to P13.)
11