Sanyo PLC-XC50 Owner's Manual page 61

Follow these steps to replace the lamp.
1 Turn off the projector and disconnect the AC power
cord. Allow the projector to cool for at least 45
minutes.
2 Loosen the screw with a screwdriver, slide and open
the lamp cover.
Loosen 2 screws of the lamp with a screwdriver and
3
pull out the lamp upwards vertically by grasping the
handle.
4 Replace the lamp with a new one and tighten the 2
screws back into position. Make sure that the lamp is
set properly. Replace the lamp cover and tighten the
screw.
5 Connect the AC power cord to the projector and turn
on the projector.
Reset the lamp replacement counter .
6
See "Resetting the Lamp Counter" on the next page .
ORDER REPLACEMENT LAMP
Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give
the following information to the dealer.
● Model No. of your projector
● Replacement Lamp Type No.
Lamp Cover
Handle
Screw
: PLC-XC50 / PLC-XC55
: POA-LMP127
(Service Parts No. 610 339 8600)
Maintenance and Care
Screw
Screw
Lamp
61