Sanyo PLC-XC50 Owner's Manual page 24

Basic Operation
AUTO SET button
Press the AUTO SET button on the remote control to
operate the Auto setup function. For more detail, see
pages 22, 28,46.
D .ZOOM buttons
Press the D.ZOOM buttons on the remote control to zoom
in and zoom out the images. For more detail, see page
36.
NO SHOW button
Press the NO SHOW button on the remote control to black
out the image. To restore to normal, press the NO SHOW
button again or press any other button. When a projected
image is captured and set as "User" in the Logo selection
(p.48), the screen changes each time you press the NO
SHOW button as follows.
black out → the captured image → normal →
KEySTONE button
For detail, see page 22.
IMAGE button
Press the IMAGE button on the remote control to select
a desired image level of the screen. For more detail, see
pages 31 and 40.
P-TIMER button
Press the P-TIMER button on the remote control. The
timer display "00 : 00" appears on the screen and the
timer starts to count time (00 : 00 ~ 59 : 59).
To stop the P-Timer, press the P-TIMER button. Press
the P-TIMER button again, then the P-timer display
disappears.
LAMP CONTROL button
Press the LAMP CONTROL button on the remote control
to select the lamp mode for changing the brightness of the
screen.
Normal . . . normal brightness
Auto . . . . . brightness according with the input signal
Eco ........... l o w e r b r i g h t n e s s r e d u c e s t h e l a m p
power consumption and extends the
lamp life.
 Note:
Lamp mode cannot be changed for a while after
turning on the projector. Lamp needs some time to
stabilize after the power is turned on. Stored lamp
mode will be active after the lamp is stabilized.
4
Remote Control
1
D .ZOOM buttons
+
_

Note:
• • • • •
The message disappears after 4 seconds.
P-Timer display
2
KEySTONE button
(See p.22)
▲▼
POINT
AUTO SET button
IMAGE button
P-TIMER button
NO SHOW button
LAMP CONTROL button
See the previous page for the other
buttons.
buttons