Pro-Form 945 CE User Manual page 11

6. Locate the wire tie (A) in the lower end of the
Upright (4). See the inset drawing. Tie the wire
tie to the Upper Wire (110) as shown. Then, pull
the upper end of the wire tie until the Upper Wire
is routed through the Upright.
Tip: To prevent the Upper Wire (110) from
falling into the Upright (4), secure the Upper
Wire with the wire tie (A).
7. Apply grease to the axle on the right side of the
Upright (4).
Next, slide a Pivot Spacer (54) onto the right
side of the Upright (4).
Then, identify the Right Upper Body Leg (60),
orient it as shown, and slide it onto the right side
of the Upright (4).
Attach the Right Upper Body Leg (60) with an
M8 x 13mm Screw (82) and an M8 x 28mm
Washer (97).
Repeat this step for the Left Upper Body
Leg (46).
6
A
A
110
7
46
11
A
110
4
4 Grease
54
60
97
82