Pelican 9460 - Remote Area Lighting System Manual

Pelican 9460 - Remote Area Lighting System Manual

Also See for 9460:

Advertisement

Pelican 9460 - Remote Area Lighting System Manual

Introduction

The Pelican 9460 Remote Area Lighting System contains two LED light heads, two masts, a 12V sealed lead acid battery and a battery charger. Both light heads connected provide a maximum output of 6000 lumens over a 7hour period. The masts will extend to a height of 6 feet.

Mast Operation

  1. Open the case and remove each mast and LED head.
  2. Attach the LED head to the mast by screwing the light head pivot into the mast insert.
  3. Close the case lid and stand the case upright.
  4. Insert the masts into the pole mounts.
  5. Insert the light head plugs into the green sockets on the sides of the product and twist the green locking collar to secure the plug.
  6. Pull open the lever on the mast locking clamp and lift the LED head upwards then snap the lever back into place.
  7. To collapse the mast reverse the procedure.

Light operation

After the light heads have been connected you can now turn them on. Press the power button once, this will default the burn time to 7 hours regardless of the power level of the battery, the condition of the battery will be indicated on the display (fig 1). To increase the burn time press button 1 (Fig2)
This will automatically decrease the light output performance). The maximum burn time is 40 hours providing combined approx. 1100 lumens output from each light head.
To decrease the burn time press button 2 (fig3), (this will automatically increase the light output performance). When the battery is fully charged the light heads will offer a maximum light output of 6000 lumens.

Power switch operation sequence

  1. Press keypad once to switch on.
  2. Press again to switch off.

Flash Mode

  1. Press and hold keypad for 3 seconds then the LED head will flash.
  2. Press keypad again to switch off.

Low Battery Warning

Before the product turns off, the LED Head will flash for 3 seconds, every ten minutes to let the user know that the battery voltage is low. The warning period starts 30 minutes before there is insufficient voltage to power the light.

Battery Charging


Do not operate the 9460 RALS with the charger connected.

HAZARD – DO NOT CHARGE THE 9460 WITH THE LID CLOSED

  1. Using the charger supplied inside the case, insert the charger plug into the charging socket situated next to the IC display.
  2. Attach the charger to the AC supply until the LED on the charger turns green.
  3. While charging the IC display will display the condition of the battery status.
  4. If the display shows a battery fail symbol this means the product will not operate until it is recharged.

Charge Cycle Indication

  1. Red = Fast Charge Mode.
  2. Yellow = 90% Charged.
  3. Green = Fully Charged Maintenance Mode.

Battery Replacement

Contact your dealer for a replacement battery.
To replace, follow the instructions included with the new battery.

Environmental

The sealed lead acid battery should be sent to a recycling centre or returned to the point of purchase.

Documents / Resources

Download manual

Here you can download full pdf version of manual, it may contain additional safety instructions, warranty information, FCC rules, etc.

Download Pelican 9460 - Remote Area Lighting System Manual

Advertisement

Need help?

Need help?

Do you have a question about the 9460 and is the answer not in the manual?

Questions and answers

Table of Contents