Connecting Water Supply; Connecting To The Drain - Beko WMI 61241 User Manual

Table of Contents

Advertisement

Installation
C
Keep the transportation safety
bolts in a safe place to reuse when
the washing machine needs to be
moved again in the future.
Never move the product without
the transportation safety bolts
properly fixed in place!

3.4 Connecting water supply

C
The water supply pressure required
to run the product is between 1 to 10
bars (0.1 – 1 MPa). It is necessary to
have 10 – 80 liters of water flowing
from the fully open tap in one minute
to have your machine run smoothly.
Attach a pressure reducing valve if
water pressure is higher.
A
WArNING:
water inlet should not be connected
to the hot water tap. In such a case
the laundry will get damaged or the
product will switch to protection
mode and will not operate.
WArNING:
water inlet hoses on the new product.
It may cause stains on your laundry.
Tighten all hose nuts by hand. Never use a
tool when tightening the nuts.
12 / EN
Models with a single
Do not use old or used
Open the taps completely after making
the hose connection to check for water
leaks at the connection points. If any leaks
occur, turn off the tap and remove the nut.
Retighten the nut carefully after checking
the seal. To prevent water leakages and
damages caused by them, keep the taps
closed when the machine is not in use.

3.5 Connecting to the drain

• The end of the drain hose must be directly
connected to the wastewater drain or to the
washbasin.
• Drain hose shall be attached to a wall drain,
stand pipe or sink siphon connected to the
foul water drain, do not connect to surface
water drains.
A
WArNING:
flooded if the hose comes out of
its housing during water discharge.
Moreover, there is risk of scalding
due to high washing temperatures!
To prevent such situations and to
ensure smooth water intake and
discharge of the machine, fix the
end of the discharge hose tightly so
that it cannot come out.
• The hose should be attached to a height of
at least 40 cm, and 100 cm at most.
• In case the hose is elevated after laying
it on the floor level or close to the ground
(less than 40 cm above the ground), water
discharge becomes more difficult and the
laundry may come out excessively wet.
Therefore, follow the heights described in
the figure.
Your house will be
Washing Machine /User's Manual

Advertisement

Table of Contents
loading

Table of Contents