Bissell Pawsitively clean SPOTCLEAN PET PLUS User Manual page 7

Cleaning with Tools
WARNING
CLEANING WITH THE 3" TOUGH STAIN TOOL
CLEANING WITH THE DEEP STAIN/REACH TOOL (select models)
CLEANING WITH THE SPRAYING CREVICE TOOL (select models)
USING THE HYDRORINSE TOOL
NOTE: Ensure that the cleaning solution and water are in the tank before use.
Keep spray away from face. Failure to do so may result in personal injury.
Attach the 3" Tough Stain Tool to the hand-held
cleaning hose. Press the spray trigger to mist solution
over and onto the soiled area. Release spray trigger
and gently scrub the stain.
To lift the stain away, apply downward pressure on the
tool and slowly pull it toward you. Then use "drying
strokes" (by not pressing down trigger) to remove
remaining moisture. Repeat as needed.
Attach the Deep Stain/Reach Tool to the cleaning hose.
Set the tool directly on top of the carpet before pulling
the spray trigger to inject formula deep into the carpet
fibers.
Always keep the tool in direct contact with carpeting
to avoid over-spraying.
Attach the Spraying Crevice Tool to the cleaning hose.
Pull the trigger to spray solution onto the soiled area.
Scrub and suction the area to lift and remove the stain.
Attach the HyrdoRinse™ tool to the cleaning hose.
Hold the hose and attachment in an upright position.
Then hold down the trigger to rinse the hose for 30
seconds.
The HydroRinse tool can be stored on the right
handle or on the hose in between use.
www.pawsitivelycleanpet.com
7