Removing the display assembly
WARNING: Before working inside your computer, read the safety
information that shipped with your computer and follow the steps in
working inside your
the instructions in
practices, see the Regulatory Compliance home page at
regulatory_compliance.
Prerequisites
1
Remove the
base
2
Remove the
wireless
Procedure
1
Turn the computer over and open the display to 180-degree angle.
2
Place the computer on a flat surface with the display facing down.
CAUTION: Place the computer on a soft and clean surface to avoid
scratching the display.
3
Peel off the tapes that secure the display cable and touch-screen board cable to
the system board.
4
Open the latches and disconnect the display cable and the touch-screen board
cable from the system board.
5
Peel off the tape that secures the antenna cables to the keyboard shield.
computer. After working inside your computer, follow
After working inside your
cover.
card.
computer. For more safety best
www.dell.com/
Before
57