Shark ION ROBOT RV755 Series Instructions Manual

Shark ION ROBOT RV755 Series Instructions Manual

Hide thumbs Also See for ION ROBOT RV755 Series:

Advertisement

RV755
Series
INSTRUCTIONS
sharkclean.com
1-800-798-7398
ION ROBOT

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ION ROBOT RV755 Series and is the answer not in the manual?

Questions and answers

Summary of Contents for Shark ION ROBOT RV755 Series

  • Page 1 ION ROBOT ™ RV755 Series INSTRUCTIONS sharkclean.com 1-800-798-7398...
  • Page 2 THANK YOU for purchasing the Shark ION ROBOT ™ REGISTER YOUR PURCHASE registeryourshark.com 1-800-798-7398 Scan QR code using mobile device TIP: You can find the RECORD THIS INFORMATION model and serial numbers Model Number: �������������������������������������� on the QR code label Serial Number: ��������������������������������������...
  • Page 3: Table Of Contents

    Using Your Shark ION ROBOT ......12 Downloading the Shark App � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � 12 BotBoundary™...
  • Page 4: Important Safety Instructions

    4 DO NOT handle charger, charging dock, and all filters in place. or Shark ION ROBOT™ with wet hands. 13 DO NOT stand or sit on the Shark ION 5 Keep charging dock away from heated ROBOT. surfaces. DO NOT expose unit or battery to fire or excessive temperature.
  • Page 5 25 Make sure that all filters are thoroughly dry blinds or curtains. Move power cords and after routine cleaning. fragile objects out of the way. DO NOT 26 Use only Shark -brand filters and ® operate unit in areas where there are lit accessories.
  • Page 6 39 Before disposing of the Shark ION ROBOT, 36 DO NOT charge at temperatures below the battery must be removed. To remove, 50°F (10°C) or above 104°F (40°C).
  • Page 7 SAVE THESE INSTRUCTIONS CONFORMITY INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
  • Page 8: Getting To Know Your Shark Ion Robot

    From assembly to use to maintenance, you will find it all in here. NOTE: When using for the first time, fully charge and discharge your Shark ION ROBOT to condition the battery. Failure to do so may cause LED indications to work incorrectly.
  • Page 9 Clean Dock Spot CLEAN BUTTON “!” ERROR INDICATOR To begin cleaning with your Shark ION When a blockage or a filter problem ROBOT™, press the CLEAN button. occurs, the “!” error indicator light will Press button again to stop. illuminate. Clear any blockages and clean filters.
  • Page 10: Charging Your Shark Ion Robot

    ON position in order to charge the battery. When the cleaning cycle is complete or the battery is running low, Shark ION ROBOT will automatically return to the charging dock. If your unit doesn’t return to the dock, the battery charge may have run out.
  • Page 11: Battery Charge Indicator Lights

    Turn the cable to the jack on the side of the Shark Power switch to the ON position. If all indicator Full Charge...
  • Page 12: Setting Up Your Shark Ion Robot

    SETTING UP YOUR SHARK ION ROBOT™ NOTE: Some carpets may cause the robot to malfunction due to pile height. IMPORTANT: Before cleaning an entire room for the first time, we recommend that you first test your unit on a small section of the floor to ensure there is no scratching.
  • Page 13: Using Your Shark Ion Robot

    USING YOUR SHARK ION ROBOT™ DOWNLOADING THE SHARK APP The app will guide you through easy setup of your Shark ION ROBOT, and allow you to schedule cleaning times and to control the unit remotely. The app will also provide access to: •...
  • Page 14: Botboundary™ Strips

    BOTBOUNDARY™ STRIPS You may need to keep Shark ION ROBOT away from certain areas, such as pet bowls, fragile objects, power strips, or doorways. Use the BotBoundary strips to quickly and easily create “no-go zones”...
  • Page 15: Cleaning Modes

    CLEANING MODES Spot Cleaning Manual Start/Stop In Spot mode, Shark ION ROBOT will thoroughly You can manually start and stop Shark ION clean an area in a spiral pattern. Use Spot mode ROBOT™. to clean a concentrated area of dust or debris.
  • Page 16: Maintaining Your Shark Ion Robot

    MAINTAINING YOUR SHARK ION ROBOT™ WARNING: Wash the dust bin and filter cover STEP 1 with water only. Be sure to air-dry them completely before reassembling. DO NOT wash the HEPA filter with water, as it may damage the filter and reduce suction power.
  • Page 17: Cleaning The Filters

    Clean the dust bin and filters with a cleaning brush. Replace the filters and the filter cover. Close the dust bin and slide it back into Shark ION ROBOT™. s h a r kc l e a n . c o m...
  • Page 18: Cleaning The Brushroll

    MAINTAINING YOUR SHARK ION ROBOT™ - cont’d. CAUTION: Turn off power before performing any STEP 1 maintenance. NOTE: When cleaning brushroll, be sure to not cut anything other than hair, string, fibers, or other debris. STEP 2 STEP 3 CLEANING THE BRUSHROLL Push up on the tabs on the brushroll access door, then lift off the door.
  • Page 19: Cleaning The Cliff Sensors And Charging Pads

    CLEANING THE CLIFF SENSORS AND REPLACING THE SIDE BRUSHES CHARGING PADS To remove a bent or damaged side brush, pull For best results, clean cliff sensors and it off its post. To install new side brush, align charging pads periodically as needed. With a hole in center of brush over post on bottom of cloth or a cleaning brush, gently dust off the unit.
  • Page 20: Cleaning The Removable Front Wheel

    MAINTAINING YOUR SHARK ION ROBOT™ - cont’d. CAUTION: Turn off power before performing any maintenance. CLEANING THE REMOVABLE FRONT WHEEL The front caster wheel on your robot is equipped with sensitive sensors and requires cleaning to maintain optimal function. Frequently check the front wheel for any tangled hair or wrapped debris.
  • Page 21: Replacing The Battery

    caster assembly before use. sharkaccessories.com REPLACING THE BATTERY When the battery needs replacement, the red “Replace” light will illuminate. To remove the battery, turn the unit over and unscrew the battery cover with a Phillips-head screwdriver. Unplug the old battery from its connector, then plug in the new battery.
  • Page 22: Tips And Tricks

    TIPS AND TRICKS FOR GREAT PERFORMANCE Your Shark ION ROBOT™ is designed with Smart Sensor technology so it can clean all areas of your floors and navigate its way out of tight spaces. During your first few cleanings, you may need to make some small adjustments to optimize your robot’s performance.
  • Page 23: Botboundary Strips

    PREPPING YOUR HOME USING BOTBOUNDARY STRIPS ™ Use the BotBoundary strips to quickly and easily create “no-go zones” to keep your robot out of the areas you would like it to avoid. These may include: • Near power cords that might cause tangles •...
  • Page 24: Troubleshooting Guide

    TROUBLESHOOTING GUIDE WARNING: Always turn off Power switch before performing any maintenance. If any error lights are illuminated or flashing on your Shark ION ROBOT , see the error ™ code chart below: ERROR CODE SOLUTION Unit is turned off. Cycle power switch. If no response, All LED lights are off plug in to charge unit.
  • Page 25: End User License Agreement

    END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE IMPORTANT: PLEASE READ THE TERMS AND CONDITIONS OF THIS LICENSE AGREEMENT CAREFULLY BEFORE CONTINUING WITH THIS PROGRAM INSTALL OR USE OF THIS PRODUCT: SharkNinja Operating LLC’s (“SharkNinja”) End-User License Agreement (“EULA”) is a legal agreement between You (either a single entity or an individual) and SharkNinja for SharkNinja’s Software Applications, including those installed by You onto your SharkNinja products or already installed on your device, including all firmware (referred hereafter as “SN APPS”).
  • Page 26 END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE - cont’d. 3. UPDATES. SharkNinja may provide You with upgrades or updates to SN APPS. This EULA will govern any upgrades provided by SharkNinja that replace and/or supplement SN APPS, unless such upgrade is accompanied by a separate EULA, in which case the terms of that EULA will govern.
  • Page 27 END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE - cont’d. 6. TERMINATION. Without prejudice to any other rights, SharkNinja may terminate this EULA if You fail to comply with the terms and conditions of this EULA. In such event, You must destroy all copies of SN APPS in your possession.
  • Page 28 END-USER LICENSE AGREEMENT FOR SHARKNINJA SOFTWARE - cont’d. 11. APPLICABLE LAW. The laws of the Commonwealth of Massachusetts will govern this EULA and You hereby consent to exclusive jurisdiction and venue in the state and federal courts sitting in the Commonwealth of Massachusetts.
  • Page 29: Warranty

    ONE (1) YEAR LIMITED WARRANTY The 1-Year Limited Warranty applies to purchases made from authorized retailers of SharkNinja Operating LLC. Warranty coverage applies to the original owner and to the original product only and is not transferable. Power pack is not covered by 1-year warranty. SharkNinja warrants that the unit shall be free from defects in material and workmanship for a period of 1 year from the date of purchase when it is used under normal household conditions and maintained according to the requirements outlined in this instruction manual, subject to the following conditions and exclusions.
  • Page 30 NOTES 1-800-798-7398...
  • Page 31 NOTES s h a r kc l e a n . c o m...
  • Page 32 SHARK is a registered trademark of SharkNinja Operating LLC. BOTBOUNDARY and SHARK ION ROBOT are trademarks of SharkNinja Operating LLC. APPLE and the Apple logo are trademarks of Apple Inc., registered in the U.S. and other countries. APP STORE is a service mark of Apple Inc., registered in the U.S.

Table of Contents