Status Indicator; Drive The Led); Application Configuration Example; Example 1: Coordinator Hex Command To Control Network Access Nodes - Ebyte E180-ZG120A User Manual

E18 V1.0 ZigBee Ad Hoc Network Module Chengdu Ebyte Electronic Technology Co., Ltd.
Sample URL: cdebyte.taobao.com For more product information, please visit: www.cdebyte.com
pressing this key)
3.4.3 Status indicator: (It is recommended that this pin be connected to a low level to

drive the LED)

This pin is usually high level, when the following events occur, it will output a continuously
changing high and low level.
Node access status：
The module is configured as routing, terminal node, and dormant terminal node. After the
first successful network access, this pin outputs a low level of 166ms 3 times, and the interval
between the two low levels is 166ms.
The coordinator created the network successfully:
The coordinator successfully created the network for the first time, the pin outputs a low level of
166ms 3 times, and the interval between the two low levels is 166ms.
Network open status:
When the coordinator starts to distribute the network, or the network of the routing node is opened
by the coordinator, this pin outputs a low level of 500ms, and outputs a low level again every
500ms, until the network is closed (including manual closing and automatic closing).
Identify tag status:
When the router or terminal node is marked by Identify, this pin outputs a low level for 500ms
until the end of the Identify mark. This function can be used to visually detect where the module
with a certain MAC address or short address is located.
Precautions:
The network open state and Identify flag state of the routing node, the output signal of this pin is
the same, so in actual operation, the two operations should be avoided at the same time.

4.Application configuration example

4.1 Example 1: Coordinator HEX command to control network
access nodes
Example introduction:
The E180ZG120 module is set up as a coordinator and creates a network. Another E180ZG120 module (normal
terminal node + transparent transmission mode) is added to this coordinator, and completes device identification,
Because professional, so choose! Wireless application experts such as wireless transparent transmission,
WiFi, Bluetooth, Zigbee, PKE, digital radio, etc.
Page 1 of 40 The copyright and the final interpretation right of the product belong to Chengdu Ebyte
Electronic Technology Co., Ltd.