LG A9-LITE Owner's Manual page 23

4
Attach the water tank to the mop nozzle again.
• Insert the 2 tabs
tank into the slots
nozzle. Press down at the centre
the tank in place.
Attaching the Mop Pads
1
Wet both sides of the mop pads with water
then squeeze out any excess water before
attaching the pads.
• Do not attach pads while they are dripping
wet.
• Attaching and using mop pads while they
are dry may affect the cleaning results.
2
Place the mop nozzle upside down on the floor.
3
Align and attach the centre of the mop pad
with the centre of the mop attachment plate.
• Attach the Velcro on the mop pad to the mop
plate. Attaching the mop pad upside down
or improperly may affect the cleaning
results.
4
Attach the mop nozzle to the appliance.
at the front of the water
e
on the top of the mop
f
to lock
g
Adjusting the Amount of Water
Press the water adjustment buttons to adjust the
amount of water released onto the mop pad to
either High Mode or Low Mode.
• High Mode: Press the High Mode button
the way down to clean ingrained dirt or supply a
large amount of water.
• Low Mode: Press the Low Mode button
way down to supply a small amount of water for
cleaning wood or other flooring that can be
damaged by too much water.
• STOP: Press the Low Mode or High Mode
button halfway to toggle back to the STOP
position. This stops the supply of water so you
can go over areas that are already wet.
WARNING
• To avoid injury, do not attach the mop pad while
the mop attachment plate is rotating.
CAUTION
• Do not let the appliance stand on the floor while
the wet mop pads are attached. Doing so may
result in damage or swelling to wood flooring.
Using with the Mop Nozzle
1
Attach the water tank and mop pads to the
mop nozzle.
2
Set the water adjustment button to the STOP
position.
3
Press the Power button to start cleaning.
OPERATION
23
all
a
all the
b