Boot lid keypad.
2. Loosen the boot lid's keypad by inserting a
flat object, such as a table knife or a
screwdriver, on each short side of the key-
pad and then prize it out. The keypad's
electrical connector does not need to be
unplugged.
Boot lid closing handle.
3. The closing handle on the inside of the
boot lid must be removed on the side
where the lamp is fitted. Press in a wide
flat object, such as a table knife edge-
ways, to press in 2 lock lugs, and fold out
the handle at the same time. When refit-
ting, a fairly hard pressure on the closing
handle is required so that the lock lugs
click into place again.
IMPORTANT
Both of the closing handle's lock lugs must
be pressed in simultaneously before the
handle can be folded out and removed.
MAINTENANCE AND SERVICE
The panel's fastening clips.
4. Remove the three outside panel clips on
the inside of the boot lid, on the side the
lamp is fitted.
}}
635