King Canada KC-10MB Instruction Manual page 8

ADJUSTING SLIDING TABLE
Adjusting the sliding table may take some trial and error. It is important that
the table slides correctly and that the blade does not make contact with the
table. The position of the adjustable table rollers (A) Fig.12 can be
adjusted inwards or outwards. To adjust a table roller position, loosen cap
screw (B), adjust the table roller position and retighten cap screw, check
your adjustment and repeat if necessary.
INSTALLING FENCES
For safety reasons, it is recommended to support any piece of meat with a
fence. To install the short (A) Fig.13 and long (B) fences to the table, first
install the fence brackets (C) using cap screws. Insert the fence shafts (D)
into each fence and secure them with cap screws. Finally, insert the fence
shafts into the fence brackets and secure them with lock knobs (E).
INSTALLING MEAT GRINDER
Important! Before installing and using meat grinder, it must be cleaned and
sanitized. If you use this bandsaw to cut meat, it is recommended to
remove the meat grinder from the saw.
Position the meat grinder (A) Fig.14B onto the meat grinder hub and secure
it in place with the lock bolt and nut (B).
This meat grinder comes with a sausage filler (A) Fig.14A, to install the
sausage filler, undo the meat grinder collar (B), and position the sausage
filler between the round knife (C) Fig.14B and the collar, reposition and
tighten the meat grinder collar.
FIGURE 14A
ASSEMBLY
FIGURE 12
FIGURE 13
FIGURE 14B