Ats - Auto Tuning System - Sangean HDR-1 User Manual

ATS – Auto Tuning System
The ATS function will scan through the selected band frequency
for all usable signals. It will create an easily navigated table for all
detected signals.
Using the Remote:
1. Press and hold "ATS" button to activate menu.
2. Press "Enter" button to activate frequency scanning.
3. Allow radio to finish scanning. Once completed you can navigate
through the available stations using the "Tune" Up/Down buttons.
To navigate to the multicast stations using ATS function press the
"Enter" button.
4. To recall ATS table navigation press "ATS" button.
Using the Unit:
1. Press "Power/Control knob" and cycle through the menu options
by rotating the "Power/Control knob" until you are at "SETUP"
menu option.
2. Press "Power/Control knob" to select.
3. Rotate "Power/Control knob" to cycle through the menu options until
you reach the "ATS SCAN" menu option.
4. Press "Power/Control knob" to select.
5. Allow radio to finish scanning. Once completed you can navigate
through the available stations by rotating the "Power/Control knob".
To navigate to the multicast stations using ATS function press the
"Enter" button.
6. To recall the ATS Table press "Power/Control knob" and cycle
through the menu options until you reach the "ATS Table'
menu option.
7. Press "Power/Control knob" to select.
8. You can begin navigating as described above.
NOTE:
While using the ATS Table, the "Power/Control knob" will no longer
control volume. You must wait until the unit returns to normal control
function, indicated by displaying the previously selected display mode.
17
20070524_HDR-1_381QB0SB-A_GB.p65
2007/5/24, ¤U¤È 03:20
14