Interrupts - Siemens SIMATIC ET 200SP Manual

Channel status/DIAG/channel fault LED
Table 6- 4
Channel
status
Flashing Flashin
6.2

Interrupts

Introduction
The F-DI 8×24VDC HF fail-safe digital input module supports diagnostic interrupts.
Diagnostic interrupt
The F-module generates a diagnostic interrupt for each diagnostic message described in
section Diagnostic messages (Page 47).
The table below provides an overview of the diagnostic interrupts of the F-module . The
diagnostic interrupts are assigned either to one channel or the entire F-module.
Table 6- 5 Diagnostic interrupts of the F-DI 8×24VDC HF
Diagnostic interrupt
Overtemperature
Parameter assignment error
Load voltage missing
Access to retentive storage of F-address not possible
Different destination address (F_Dest_Add)
Invalid destination address (F_Dest_Add)
Invalid source address (F_Source_Add)
Watchdog time is 0 ms (F_WD_Time or F_WD_Time2)
"F_SIL" parameter exceeds the application-specific SIL
"F_CRC_Length" parameter does not match the generated CRC
Digital input module F-DI 8x24VDC HF (6ES7136-6BA00-0CA0)
Manual, 07/2013, A5E03858068-01
Meaning of the channel status/DIAG/channel fault LED
DIAG Channel
fault
Off Flashin All On
g
Off
g
Meaning
The PROFIsafe address does not match the configured
PROFIsafe address
Identification of the F-module when assigning the PROFIsafe
address
Fault Signaled in
code application
5 1, 2, 3
D
16
D
17
D
30
D
64
D
65
D
66
D
67
D
68
D
69
D
Interrupts/diagnostic messages
6.2 Interrupts
Scope of Configurable
diagnostic
interrupt
F-module No
45