Advertisement
2
Assemble parts
shown. Leave the
lens and small
gasket off until
step #6.
Panel thickness range
(inches)
16 ga – 14 ga
(0.060 – 0.075)
13 ga – 10 ga
(0.090 – 0.135)
9 ga – 7 ga
(0.150 – 0.188)
—
Step 4
Locknut wrench
Cat. no. A3XGLW
—
Step 5
Tighten locking nut to 40 ± 2 in-lb [4.5 Nm] recommended torque.
Contact operation:
Torque contact block retaining screws to 8 – 10 in-lb [0.9 – 1.1 Nm]
Torque light module retaining screws to 4 – 5 in-lb [0.5 – 0.6 Nm]
Maintained push-pull
Normally open contacts — use A3XC10 contact block
Normally closed contacts — use A3XC01 contact block
Momentary push-pull (factory assembled)
Normally open contacts — use A3XC01 contact block (becomes normally open when assembled)
Normally closed contacts — use special A3XC1EL contact block which must be mounted last
—
USA
ABB Inc.
305 Gregson Drive
Cary, NC 27511
abb.com/low-voltage
Gaskets
required
—
We reserve the right to make technical
changes or modify the contents of this
document without prior notice. With regard
to purchase orders, the agreed particulars
shall prevail. ABB Inc. does not accept any
responsibility whatsoever for potential
errors or possible lack of information in
this document.
—
Step 6a
Plastic lens
1. Place small gasket inside nut.
2. Insert mushroom head/pushbutton
into switch body.
3. Tighten securely by hand.
3
—
Replacement bulb chart
2
Incandescent
1
Volts
bulb
6
#755*
A3XBL6R
24
#757
A3XBL2R
120
N/A
A3XBL4R
*Also flashing lamp #267
We reserve all rights in this document
and in the subject matter and illustrations
contained therein. Any reproduction or
utilization of its contents – in whole or in
parts – is forbidden without prior written
consent of ABB Inc. Copyright© 2021 ABB.
All rights reserved.
—
Step 6b
LED lamp – single bulb
Red
Green
Yellow
A3XBL6G
A3XBL6Y
A3XBL6W
A3XBL2G
A3XBL2Y
A3XBL2Y
A3XBL4G
A3XBL4Y
A3XBL4Y
White
Blue
A3XBL6L
A3XBL2L
A3XBL4L
Advertisement
